• Domestic & Commercial
• Fault Finding & Repairs
• 3 Phase Commercial Circuit Faults • Immersion Heaters
• Fuse Board Replacement • New Installations
• Test and Inspection • Landlord’s safety checks
• Portable Appliance Testing (PAT Testing)
• Computer Network Design & Installation
All rewires will comply with the BS7671 regulations and include new cabling and
fittings, new consumer unit including MCBs and RCD. All relevant bonding to
BS7671 regulations. Full IEE certificate on completion.
Domestic and Commercial
Fault finding to power and lighting circuits
Fuse board problems
Low voltage lighting faults
Blown fuses – tripping MCBs
Low voltage lighting
New shower circuits
New cooker circuits
Additional power sockets
Wiring of outbuildings/workshops
3 phase installations
New light fittings
Upgrade of consumer units (to include RCD and MCBs)
Updating of Earth Bonding
Testing and Inspection
Testing to BS7671
We provide inspection and testing of fixed electrical
installations and equipment (up to and including three phase 415V ac circuits),
in domestic, commercial and industrial environments, in accordance with BS 7671
2008 (Institution of Electrical Engineers (IEE) Wiring Regulations - 17th Edition).
All electrical installations should be inspected and tested on a regular basis.
The time interval between inspections is dependant on the type of installation
e.g. domestic installations may be a maximum of 10 years whilst a construction
site may require inspection at 3 monthly intervals. The periodic inspection and
test includes a thorough visual inspection looking at all aspects of the
electrical installation together with extensive testing. We can inspect and test
your installation and issue you with a 'Periodic Inspection Report' which,
together with a 'Schedule of Inspections' and a 'Schedule of Tests'', will
confirm that the installation is safe and 'fit for purpose' and will also
identify any areas that require remedial work to satisfy the IEE regulations.
Regular inspections also need to be performed on electrical installations
between Periodic Inspections, usually on an annual basis, as damage and deterioration can occur. To meet this requirement we offer a less comprehensive
inspection which is limited to a visual inspection and some functional testing.
This is particularly suited for rental properties where there may be an annual
change of tenant.
This is a low cost option particularly suited to potential home buyers. A visual
inspection of the electrical installation is carried out to determine the age of
the wiring and accessories, it's general condition and compliance with current
standards. If the installation is found to be generally satisfactory, a full
inspection including testing of circuits can be carried out if requested by the
Portable Appliance Testing
The Health & Safety Executive states that 25% of all
reportable electrical accidents involve portable appliances. The Electricity at
Work Regulations place a legal responsibility on employers, employees and
self-employed persons to comply with the provisions of the regulations and take
reasonably practicable steps to ensure that no danger results from the use of
such equipment. We can inspect and test appliances as either part of a Periodic
Inspection, Landlord's check or separately as required.
Should any problems be found, these can be costed and rectified with no additional charge
for a re-test.